Model
DT2-6
6"
Duct Take-Off |
Use the DT2-6 kit so exhaust can be removed from
outside the mechanical room if necessary. The DT2-6
can also be used to duct outside supply air to a
room where the XCHANGER™
is not installed in. (Flex duct not
included).
DT2-6 Instructions |
|
Model SC-1
Speed Control |
Use to turn Duct Fans on/off and to
vary motor RPM. Can be used in series with PS1503 Duct Airstat
and with Models EA-5,
EF-6, EF-8,
& EF-10 (Can be mounted in junction box of models EF-6, 8, 10).
|
|
Model SCP
Speed Control |
Use to turn P & M Series inline fans on/off and to
vary motor RPM. Can be used in series with PS1503 Duct Airstat.
Plug fan cord directly into speed control
and speed control directly into outlet.
|
Wireless Remote
Control |
Simply plug the cord of any device into
the wireless control and plug the control
into the outlet. Great for tough to reach
applications and for saving time on
installation. Unit can also be turned on and
off with remote or a button on the wireless
control itself. Control works up 100 feet
away and through walls, floors, etc.
|
|
|
G-Series
Grilles |
White plastic, exhaust or intake grilles with
mounting collars (4", 6", 8" Sizes).
| G-4 4" Grille |
$24.95 |
|
|
G-6
6" Grille |
$29.95 |
|
|
G-8
8" Grille |
$39.95 |
|
|
|
Model 950-3310
Line Voltage
ThermostatU.L. Approved
C.S.A. Certified
Elec. Rating: 22 Amps@ 125 V
Temperature Range: 50° to 90° |
Suitable for direct connection with Tjernlund Duct
Booster® duct fans and AireShare™ room-to-room
ventilators. Included with the thermostat package is
a single gang plastic electrical box to allow for
easy and safe installation.
Snap action switch operated by a bimetal actuator
and is double pull, single throw. This thermostat
allows Tjernlund units to be activated by either
heating or cooling, but not both with the same
thermostat.
|
|
|
BD-Series
Back Draft Dampers |
Galvanized steel,
spring loaded dampers prevent back drafts (4", 6",
8" Sizes).
BD-4
4" Damper |
$29.95 |
|
BD-6
6" Damper |
$39.95 |
|
BD-8
8" Damper |
$49.95 |
|
|
|
|
PS-Series
Pressure Switch
|
| PS1503: Senses
positive pressure from central blower. Works
year-round for both heating and A/C. Simplifies
wiring. |
|
|
$59.95 |
|
PS1503 Instructions
PS2501: Senses positive, negative or
differential pressures from central blower
and has an adjustable set point. Works year
round for both heating and A/C. Simplifies
wiring. |
|
|
$89.95 |
|
|
|
Power Cord Kit |
Includes 6' grounded power cord,
strain relief bushing, 3 wire nuts.
Compatible with any Tjernlund product. |
|
|
$19.95 |
|
|
Fireplace Blower
Switch |
Switch closes to allow power to the blower
at temperatures of 150°F and greater (ideal
for fireplace applications).
Place
this switch on the underside or back of the
fireplace that warms as the fire starts and
grows. As that surface warms the switch will
make and allow power to the fan. Once the
temperature of the surface falls below 150°F
the switch will open and the blower will
turn off. The switch will automatically
reset itself and be ready for the next fire.
Installs in minutes. Two mounting
holes allow for easy attachment. This switch
is compatible with any and all fireplace
blowers and for many other applications.
Item is roughly 1.5" tall and .75" wide, as
pictured. |
|
|
$14.95 |
|
|
|
Model DR-10
Activation Control |
A Dryer Vent Switch used to
automatically activate M-Series Duct Booster®
Fans when
dryer is in operation.
|
|
